I got a hardware setup to power 40 servos and only use one USB2Dynamixel adapter. So i can address all 40 servos directly with one control software, only need to handle one usb-port. 

Here is a picture, where you can see that every 6-port-hub is connected with its own power supply and every 6-port-hub is then inter-connected with each other only with the data-line of the 3-pin connector.

On every 6-port-hub then are 4-hubs available for servo-use.

<img src="/uploads/ros/original/1X/b9653e2e0dabced2db89e104d73a5c01b4f80edb.jpg" width="690" height="492">






---
[Visit Topic](https://discourse.ros.org/t/robotic-humanoid-hand/188/54) or reply to this email to respond.


If you do not want to receive messages from ros-users please use the unsubscribe link below. If you use the one above, you will stop all of ros-users from receiving updates.
______________________________________________________________________________
ros-users mailing list
ros-users@lists.ros.org
http://lists.ros.org/mailman/listinfo/ros-users
Unsubscribe: <http://lists.ros.org/mailman//options/ros-users>