These are amazing, I just heard about the project today (tb3 compared to tb1 which I knew of). Any chance you can test one with a space in the middle, or even an upside down U shape, because I want to run a gantry along the middle with hopefully cnc 3d print/route/drill along the full length, ideally it would be able to print skeleton supports to drive up as it printed an object. Imagine it printing a corkscrew pair of ramps which it drove up as the model layers were printed. A bit wasteful until you consider it could then potentially do prints of any size... --- [Visit Topic](https://discourse.ros.org/t/tb3-payload-test-of-turtlebot3/827/7) or reply to this email to respond. If you do not want to receive messages from ros-users please use the unsubscribe link below. If you use the one above, you will stop all of ros-users from receiving updates. ______________________________________________________________________________ ros-users mailing list ros-users@lists.ros.org http://lists.ros.org/mailman/listinfo/ros-users Unsubscribe: