@Sinai_Aranda: perhaps you can use [Danfoa/invite-robotics](https://github.com/Danfoa/invite-robotics) as inspiration. It is for an SDA10, but that should be almost a search->replace action at this level. The `invite_motoman_support` pkg shows you how to configure the `controller_joint_names` and the other required parameters. Note that the pkgs in `Danfoa/invite-robotics` contain a lot of other things (for integration of a gripper fi) that you can ignore. Also note that they are essentially a customised version of the pkgs in `ros-industrial/motoman` and `ros-industrial/motoman_experimental`. --- [Visit Topic](https://discourse.ros.org/t/using-the-motoman-sda20d-dual-arms-dx100-ros-interface-indigo/4667/6) or reply to this email to respond. If you do not want to receive messages from ros-users please use the unsubscribe link below. If you use the one above, you will stop all of ros-users from receiving updates. ______________________________________________________________________________ ros-users mailing list ros-users@lists.ros.org http://lists.ros.org/mailman/listinfo/ros-users Unsubscribe: