Nope, but If one showed up on my desk I would gladly do so. ;)

I've programmed a mecanum drive system quite a few times over the years,
The algorithm is dead simple!

I've also built a three wheel'd bot very similar to that as well but I
never got around to putting a controller in it.

In either case, my experiences have shown it to be very important that you
incorporate a gyroscope into your controller to keep the robot moving in a
straight line, unless you are just going to drive it around with a joystick.


All the best!

~Dereck


“The greater danger for most of us lies not in setting our aim too high and
falling short; but in setting our aim too low, and achieving our mark.” -
Michelangelo


On Thu, Sep 12, 2013 at 8:15 PM, Dejan Pangercic
<dejan.pangercic@gmail.com>wrote:

> Dear ROSistas,
>
> does anyone of you have experience or have even written drivers for
> any of these 2 robots:
> http://www.robotshop.com/4wd-arduino-compatible-mecanum-robot-kit-3.html
> http://www.robotshop.com/3wd-100mm-omni-directional-kit.html
>
> Any feedback would be very appreciated.
>
> Thx, D.
>
>
> --
> Dejan Pangercic
> Autonomous Technologies Group
> Robert Bosch LLC
> Office: +16505657403
> Cell: +16508610951
> E-Mail: dejan.pangercic@gmail.com
> WWW: http://ias.cs.tum.edu/people/pangercic
> _______________________________________________
> ros-users mailing list
> ros-users@code.ros.org
> http://lists.ros.org/mailman/listinfo/ros-users
>