[ros-users] Pr2 Front Bottom Panel Removal

[Blaise Gassend]

If you are talking about the base cover, then it just clips in. The
spine has to be up to remove the cover. I have had best luck pulling up
on the sides of the cover toward the front. It is always a bit tricky...

Note: this is not an authoritative answer.

On Mon, 2010-06-21 at 16:34 -0700, Adam Stambler wrote:
> Hi,
> 
> We are trying to remove the PR2 front Bottom Panel and want to make
> sure we are taking it off correctly.  Are there screws securing the
> panel or does it just clip in?  If there are screws, which screws on
> the outside belong to the panel?  If there are clips, what is the best
> position pull/push in to remove the panel?
> 
> Thank you for the help, in the future I will post these questions to
> the PR2-users mailing list.
> 
> Regards,
> Adam Stambler
> 
> On Mon, Jun 21, 2010 at 4:23 PM, Adam Stambler <adasta at gmail.com>
> wrote:
>         Hello,
>         
>         We are trying to remove the PR2 front Bottom Panel and want to
>         make sure we are taking it off correctly.  Are there screws
>         securing the panel or does it just clip in?  If there are
>         screws, which screws on the outside belong to the panel?  If
>         there are clips, what is the best position pull/push in to
>         remove the panel?
>         
>         
>         Regards,
>         Adam Stambler
>         
>         
> 
> _______________________________________________
> ros-users mailing list
> ros-users at code.ros.org
> https://code.ros.org/mailman/listinfo/ros-users