I just tried out a few things from your pioneer_control package and I
get the same behavior I was seeing before.
-Dan
On 4/21/10 7:13 PM, Dan Lazewatsky wrote:
> Hi Tucker,
> I think that should be enough to get me going.
>
> Thanks!
> -Dan
>
> On 4/21/10 6:57 PM, Tucker Hermans wrote:
>> Hi Dan,
>>
>> I send the MotorState command of 4 and have no problems.
>>
>> I have a teleop keyboard port which I use for communicating with the
>> p3dx that you can find here:
>> github.com/trhermans/AffLearning/tree/master/pioneer_control/
>> <http://github.com/trhermans/AffLearning/tree/master/pioneer_control/>
>>
>> Note: the launch file is setup for a p3dx with a PTZ connected to an
>> onboard computer and uses the probe camera driver to get the video
>> stream.
>>
>> I have only been testing the changes to the p2os package on a p3dx
>> with an onboard computer, I don't think this should have any issues,
>> but it could. Let me know if the keyboard operation gives the same
>> problems you have now and I'll try and help debug it.
>>
>> -Tucker
>>
>> On Wed, Apr 21, 2010 at 7:49 PM, Dan Lazewatsky
>> <lazewatskyd@cse.wustl.edu <mailto:lazewatskyd@cse.wustl.edu>> wrote:
>>
>> Hi all -
>> I know this has been discussed here a bit, but not in much detail.
>> We have a Pioneer3dx that we'd like to get up and running again. I
>> downloaded and compiled the p2os package which seems to be able to
>> successfully connect and communicate with the robot using a serial to
>> USB adapter. However, I'm having trouble getting the motors to do
>> anything sensible. The robot's motor self-test looks like it
>> works fine,
>> but sending cmd_vel, all I can get is extremely slow, jerky movement
>> forward or backwards (no turning). I enabled the motors with:
>>
>> rostopic pub cmd_motor_state -1 p2os/MotorState 1 (I also tried 4
>> instead of 1 which was mentioned in a previous discussion)
>>
>> This feels like a communication problem between the motor
>> commands p2os
>> is sending and the robot, but I don't know what's going on. Any
>> ideas?
>>
>> Thanks,
>> -Dan
>> _______________________________________________
>> ros-users mailing list
>> ros-users@code.ros.org <mailto:ros-users@code.ros.org>
>> https://code.ros.org/mailman/listinfo/ros-users
>>
>>
>>
>> _______________________________________________
>> ros-users mailing list
>> ros-users@code.ros.org
>> https://code.ros.org/mailman/listinfo/ros-users
>>
>
>
> _______________________________________________
> ros-users mailing list
> ros-users@code.ros.org
> https://code.ros.org/mailman/listinfo/ros-users
>
(text/plain)