@gavanderhoorn: both manipulator and positioner are integrated with a DX200 controller. Here is Eric Marcil's answer to a similar question:
> Yes, the same controller will support both the robot and the station. Each one is considered a control group.
>
>So any example combining two robots is essentially the same as combining a robot with a station. The only difference is that the station has less joints.
>
>If you look in the simple message structure there is a field for groupNo. For your system:
>
> 0 = robot
> 1 = station
>
>If I remember correctly, there are two approaches.
>
>You can send multiple messages for each group using SmBodyJointTrajPtFull
>Or you can send a single message with multiple group info using SmBodyJointTrajPtFullEx
>
>I believe that the second one is usually recommended if you are trying to coordinate the motion between both groups.
So I think our system is in deed setup as a multi-group system. It has actually not been delivered yet but we should have it up and running some time in March. So far, I have been running `moveit_planning_execution.launch sim:=true` to simulate the robot and that is when I've run into the above errors. So the question would also be whether the industrial robot simulator has multi-group capabilities since simulating the robot prior to execution is also required.
I have not configured the `motoman_driver` but will look into that next.
---
[Visit Topic](
https://discourse.ros.org/t/integration-of-6-axis-manipulator-and-2-axis-positioner-external-axes/7931/9) or reply to this email to respond.
If you do not want to receive messages from ros-users please use the unsubscribe link below. If you use the one above, you will stop all of ros-users from receiving updates.
______________________________________________________________________________
ros-users mailing list
ros-users@lists.ros.org
http://lists.ros.org/mailman/listinfo/ros-users
Unsubscribe: <
http://lists.ros.org/mailman//options/ros-users>