Hi,
Somebody know if ROS have support for this motor, PowerCube pr70 ??,
I am traying with cob_powercube_chain, but I think that my motor is not
supported by this, because the command data that is sending not correspond
with the command data that could accept my motor.
I am trying of install "schunk_powercube_controllers",
"
https://cmu-ros-pkg.svn.sourceforge.net/svnroot/cmu-ros-pkg/trunk/schunk_powercube_controllers/
"
I have saw in the code the correct commands for my motor, but I cant install
it, Always I obtain a error when I compile it.
I attached two images.
http://dl.dropbox.com/u/2950889/PowerCube1.jpg
http://dl.dropbox.com/u/2950889/PowerCube2.jpg
Best regards.
--
Atentamente,
Aarón Martínez Romero
Ingeniero en Informática
Tlf: 600 283 349
http://www.AaronMR.com