If you are talking about the base cover, then it just clips in. The
spine has to be up to remove the cover. I have had best luck pulling up
on the sides of the cover toward the front. It is always a bit tricky...
Note: this is not an authoritative answer.
On Mon, 2010-06-21 at 16:34 -0700, Adam Stambler wrote:
> Hi,
>
> We are trying to remove the PR2 front Bottom Panel and want to make
> sure we are taking it off correctly. Are there screws securing the
> panel or does it just clip in? If there are screws, which screws on
> the outside belong to the panel? If there are clips, what is the best
> position pull/push in to remove the panel?
>
> Thank you for the help, in the future I will post these questions to
> the PR2-users mailing list.
>
> Regards,
> Adam Stambler
>
> On Mon, Jun 21, 2010 at 4:23 PM, Adam Stambler <adasta@gmail.com>
> wrote:
> Hello,
>
> We are trying to remove the PR2 front Bottom Panel and want to
> make sure we are taking it off correctly. Are there screws
> securing the panel or does it just clip in? If there are
> screws, which screws on the outside belong to the panel? If
> there are clips, what is the best position pull/push in to
> remove the panel?
>
>
> Regards,
> Adam Stambler
>
>
>
> _______________________________________________
> ros-users mailing list
> ros-users@code.ros.org
> https://code.ros.org/mailman/listinfo/ros-users
(text/plain)